In this article I talk about two products:
- Colorless varnish Isotec Insulation Spray 300 ml Implastec
- Dessoldadora Tape – Dessoldadora Hikari Mesh – 1,5m 3 mm
Both were also purchased for my project to install a against 2600Tim RGB Worhington to my Atari 2600 the Polivoks with American Board Rev. 17.
All the welds of the Atari 2600 are covered by a varnish originally. As to -transcoding for NTSC and the installation of the against involved moving in some components and change some welds, I thought it prudent to spend a varnish again, for the new welds lasting as much as the original. That is where it comes the Colorless varnish Isotec Insulation Spray 300 ml Implastec. I used it in all the welds that did on the Board Atari 2600.
A Dessoldadora Tape – Dessoldadora Hikari Mesh – 1,5m 3 mm It was acquired for the purpose of auxliar in removing components in this same project. Crystal oscillator, resistor, capacitor, voltage regulator, etc. But I confess that I ended up not using. The desolder realized comment. But I kept it for future work.
Check out some photos from the Colorless varnish Isotec Insulation Spray 300 ml Implastec and by Dessoldadora Tape – Dessoldadora Hikari Mesh – 1,5m 3 mm:

Colorless varnish Isotec Insulation Spray 300 ml Implastec and Dessoldadora Tape – Dessoldadora Hikari Mesh – 1,5m 3 mm
Leave a comment