[Review] Covers for Consoles of the Printer Boy: Sega Genesis II, Atari 2600 Woody, e Playstation 3 Fat

This is my third purchase of covers on the Printer Boy consoles. Be sure to check the articles the first two purchases:

1. Covers for Consoles of the Printer Boy: Sega Genesis, Super Nintendo, Playstation One, Nintendo Switch, 13/08/2018.
2. Covers for Consoles of the Printer Boy: Atari 2600 Vader, Master System e Playstation 4, from 01/11/2018.

In this third shipment asked to cover three of my consoles:

1. Mega Drive III da Tec Toy
2. Atari 2600 Woody
3. Playstation 3 Fat

Note that for Mega Drive III da Tec Toy I chose the cover of Sega Genesis II, because there is no specific covers for the Brazilian models.

With mine Playstation 3 Fat stand up, I chose the cover in the version for the console standing.

Check out the photos and video of this third shipment covers the Printer Boy:

In the case of Atari 2600 Woody, the cover is slightly raised on the rear right corner on behalf of audio cables and S-Video, that they were added by against, and because of that the cover does not have their existence. But nothing much disturb.

See also the video of unboxing this third shipment covers the Printer Boy:

Another point worth a note. All covers that bought the Printer Boy so far have been in Loja dele no Etsy. But now it also has a shop with system and self-control.

Now there are also two choices of material for the covers: fabric and vinyl. Before there was no option and all the covers were woven (fabric). Therefore, all my covers are fabric.

In my next shopping I intend to switch to vinyl, that is washable, especially for clear cases, for I fear that they are grimy with time and it would be good wash them power.

This package also was caught by surprise by postal order rate, because the Printer Boy packages are sent by registered mail, and this package was already in transit when the damn Post invented the new rate.

These are the tracking information package, according to the Post Office site:

Finally, the purchase summary table:

Once again I was quite satisfied with the covers for the Printer Boy video game consoles. Currently all my consoles are already installed with their capes, except Playstation 4 For e o Analogue Super Nt.

The Playstation 4 For I had not yet cover option standing when I made the last purchase, but now have. But, he heats up in standby mode, so I do not know whether to leave him with cover. But I possibly buying it.

As for the Super Analogue Nt, the Printer Boy does not have to cover it. But as it already does cover for Retron 5, no doubt end up doing for the Super Analogue Nt also.

And you? How do to protect their consoles powder videogames? use cases? Let all saved? Lets eating dust and does not care? Plastifica os consoles e nunca joga? Leave your comment.