The 2 Fans (Fans) 70x70x15mm with Ball Bearings and the USB Extender Cable 3.0 Vention 50cm were acquired on AliExpress, stores JIESAMMY StoreX and VEnTIOn Electron Franchised Store, respectively. It was the first time I used the service AliExpress Direct, combining orders from more than one store in a single package so we can save on shipping.
Motivation
The 2 Fans (Fans) 70x70x15mm with Ball Bearings were purchased for use with my Roteador ASUS RT-AC86U, already shown here on Skooter Blog. I had already acquired specific fans for the RT-AC68U, who has also shown here in Skooter Blog, but over time they were getting noisy.
My expectation is that these new fans, with ball bearings, are more durable. However, the USB Fan Speed Controller (Fans) and ZK-BUFS LED Dimmer that I acquired recently has already solved the problem in a way, because with low speed the old fans make almost no noise.
Because of this I decided to postpone the installation of Fans (Fans) 70x70x15mm with Ball Bearings until they are really needed, so in this article I only do one unboxing.
The USB Extender Cable 3.0 Vention 50cm was acquired because I imagined that the ZK-BUFS USB Fan Speed Controller could not fit directly plugged into a USB port behind the Roteador ASUS RT-AC86U. Fortunately it didn't, so I also had no use for it at the time.
If I needed, any simple USB extender would work, after all only the power wires are used, the data ones are idle. But I chose to buy the USB Extender Cable 3.0 Vention 50cm because it can have other uses, in particular that of powering external hard drives, whose cables are usually short and do not always allow you to connect to any USB port that is away from a surface to place it.
I've had this problem in the past, because my Cooler Master Haf X case has the external USB ports on the top, so that the external hard drive could only stay on top of it, but right above it is a built-in cabinet whose door would not open with the HD there. You can't use the rear doors either, because the cupboard is right above the cabinet, no space for HD. I only solved this by connecting the HDD first with a extensor USB, and then with a Hub USB.
Moreover, I still have this problem elsewhere. In my work there is a PC with an external HD half hung, standing against the cabinet, because the wire is too short for it to sit on the table.
A third possible use for USB Extender Cable 3.0 Vention 50cm is next to U96 USB testator, which is also bulky and can keep the display in an unfavorable position, depending on the position where the USB port to be tested is.
Unboxing
I received a single package, with LB tracking + 9 digits + SE. Inside were the two packages, one from each seller, with LP code + 15 digits. Apparently the packages go separate to some extent and then come together to come to Brazil in one freight.
The 2 Fans (Fans) 70x70x15mm with Ball Bearings are brand Pengda Technology and came in individual bags. The USB Extender Cable 3.0 Vention 50cm came sealed in the traditional Vention packaging.
Check out the photos and the video of the unboxing of 2 Fans (Fans) 70x70x15mm with Ball Bearings and the USB Extender Cable 3.0 Vention 50cm:
- Package with 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm.
- Package with 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm.
- 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings.
- 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings.
- 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings.
- 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings.
- USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm, on its packaging.
- USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm, on its packaging.
- 2 Fans (Fans) 70x70x15mm with Ball Bearings and package with USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings, and USB Extender Cable 3.0 Vention 50cm.os 2 Fans (Fans) 70x70x15mm with Ball Bearings and USB Extender Cable 3.0 Vention 50cm, in their packaging.
Tracing
These are the package tracking information with the 2 Fans (Fans) 70x70x15mm with Ball Bearings obtained from the AliExpress system:
2020.06.18 12:00 (GMT-7): Delivery successful 2020.06.16 08:12 (GMT-7): Cleared customs 2020.06.15 15:17 (GMT-7): Accepted by Last Mile Carrier 2020.05.11 23:00 (GMT-7): Departed country of origin 2020.04.27 13:36 (GMT-7): Shipment accepted by airline 2020.04.26 16:13 (GMT-7): Shipment left country of origin warehouse 2020.04.26 16:00 (GMT-7): Shipment at country of origin warehouse 2020.04.24 16:58 (GMT-7): Shipment dispatched
These are the package tracking information with the USB Extender Cable 3.0 Vention 50cm obtained from the AliExpress system:
2020.06.18 12:00 (GMT-7): Delivery successful 2020.06.16 08:12 (GMT-7): Cleared customs 2020.06.15 15:17 (GMT-7): Accepted by Last Mile Carrier 2020.05.11 23:00 (GMT-7): Departed country of origin 2020.04.27 13:36 (GMT-7): Shipment accepted by airline 2020.04.26 16:13 (GMT-7): Shipment left country of origin warehouse 2020.04.26 16:00 (GMT-7): Shipment at country of origin warehouse 2020.04.20 16:31 (GMT-7): Shipment at country of origin distribution center
And these are the information obtained on the site of the station:
18/06/2020 11:59 [REMOVED] / SP Object delivered to the recipient 18/06/2020 10:10 [REMOVED] / SP object out for delivery to the recipient 17/06/2020 09:09 INDAIATUBA / SP Objeto encaminhado de Unidade de Tratamento em INDAIATUBA / SP for distribution Unit in [REMOVED] 16/06/2020 08:28 CURITIBA / PR Objeto encaminhado de Unidade de Distribuição em CURITIBA / PR for Treatment Unit in INDAIATUBA / SP 16/06/2020 08:26 CURITIBA / PR finalized Customs supervision 15/06/2020 15:23 CURITIBA / PR Objeto recebido pelos Correios do Brasil Informar nº do documento para a fiscalização e entrega do seu objeto. Click here My Imports 06/05/2020 14:26 SWEDEN / Objeto encaminhado de País em SUECIA / countries in International treatment unit / BR Informar nº do documento para a fiscalização e entrega do seu objeto. Click here My Imports 06/05/2020 14:25 SWEDEN / Objeto recebido na unidade de exportação no país de origem Informar nº do documento para a fiscalização e entrega do seu objeto. Click here My Imports 06/05/2020 12:42 SWEDEN / Objeto postado Informar nº do documento para a fiscalização e entrega do seu objeto. Click here My Imports
Table-Summary
This is the table-summary of purchase.
Product Name: |
|
Name Original: |
|
Store: | AliExpress | Stores: JIESAMMY StoreX and VEnTIOn Electron Franchised Store |
Value: |
|
Current value: |
|
Payment Method: | Credit Card Visa International |
Shipping Type: | AliExpress Direct |
Shipping Fee: |
|
Package Home Country: | China |
Purchase Data: | 16/04/2020 |
Submission Date: |
|
Data Delivery: | 18/06/2020 |
Time in Transit: | 55 days |
Declared content: | Fans & Cooling |
Type Marked Content: | Others |
Declared Value: | USD $13.98 |
Taxed: | Not |
Taxable Value: | - |
Tax Value: | - |
Final Considerations
The 2 Fans (Fans) 70x70x15mm with Ball Bearings seem of good quality, but I will only know about their noise when I put them to work. I couldn't test them because of the 2 pins, that I have nowhere to connect. It is necessary to use them not ASUS RT-AC86U I will have to cut the wires and splice them into a cable with a USB plug.
The USB Extender Cable 3.0 Vention 50cm eu nem fiz questão de abrir e testar, pois já conheço a qualidade da Vention. Deixei-o lacrado até que precise usa-lo.
Share this article with your friends if you liked . If you also want to shop in AliExpress, directly from Hong Kong, click here and good shopping.
[…] were purchased from AliExpress ASMTLED Official Store. The idea is to use one of them in conjunction with 2 Fans (Fans) 70x70x15mm with Ball Bearings, already shown here in Skooter Blog, and with that I can connect them to my ASUS RT-AC86U Router, also already shown here on Skooter […]